Table of Contents
Advertisement
Operating instructions
4.3 After use – Cleaning
HACCP is a preventive inspection system to ensure hygiene requirements are
met during the washing process and cleaning of the machine. As a result of its
design, the machine meets strict hygiene requirements. Regular, thorough clean-
ing is also important from a hygiene perspective. A machine that is properly
cleaned helps produce a good wash result, reduces the risk of dirt accumulating,
increases the service life of the machine and reduces the risk of emergency shut-
down.
See the WEB Tool manual for the HACCP alarm options.
•
•
4.3.1 Incorrect cleaning methods
N.B.! An incorrect cleaning method may damage the machine. The following
points must be observed:
•
•
•
•
Steel wool and pressure washers must not be used for cleaning
WD-153 - WD-423
All internal cleaning can and should take place from the front side of the
machine to avoid the risk of crushing injuries beside the feed cradle.
If any items become trapped in the feed cradle, these can be released us-
ing a 13 mm double-ended spanner to turn the feed crank clockwise.
Do NOT use steel wool as it will cause corrosion to form on the machine.
If detergent is used, it must not contain abrasives. Detergents containing
abrasives will damage the stainless steel panels.
The exterior of the machine must not be hosed. Water can enter the ma-
chine and damage the touch panel and electrical equipment.
Pressure washers and steam can damage the machine and must NOT be
used for cleaning purposes. Never use a pressure washer to clean the floor
within 1 metre of the machine. The supplier cannot be held liable for any
faults caused by the use of pressure washers on the machine and any such
use may invalidate the warranty. There is a risk of splashing even if the
floor is hosed down.
WD9_07
53
optiflow
Rev. 00 (202310)
Advertisement
Table of Contents
