Buttons And Switches; Power Switch; Panel Button; Dip Switches - Epson TM-U200 Series Technical Manual

C o n fid e n tia l

Buttons and Switches

Power Switch

Type:
Function:
Note:
Turn on the power only after connecting the power supply.

Panel Button

The panel button is enabled or disabled by the ESC c 5 command. This button is inactive if it is
disabled.
Feed (FEED) button:
Note:
The E E E E S S S S C C C C c c c c 5 5 5 5 command enables or disables the panel button. When disabled, the button does not function.
However, when loading a paper roll, you can feed paper with the FEED button during the paper loading
waiting time if the paper loading waiting time is set by G G G G S S S S z z z z 0 0 0 0 . Press the FEED button again after the
PAPER OUT LED starts blinking to return the printer to the on-line state.

DIP Switches

Serial interface (RS-232 and RS-485 (option))
The DIP switches are located at the bottom of the case.
DIP switch 1
DIP Switch Function
1 Data receive error
2 Receive buffer capacity
3 Handshaking
4 Data word length
5 Parity check
6 Parity selection
7 Baud rate selection
8 Busy condition
1-24 Features and General Specifications
Rocker switch
The power switch turns the power on or off.
Type: Non-locking push button
Function: Feeds paper based on the line feed amount set by ESC 2
and ESC 3.
ON
Ignored
Data buffer 40 bytes
XON/XOFF
7 bits
Yes
Even
4800 bps
When the receive buffer is full
OFF
Prints "?"
Data buffer 1000 bytes (Type A)
Data buffer 512 bytes (Type
AM)
DTR/DSR
8 bits
No
Odd
9600 bps
When the receive buffer is full in
off-line status
Rev. A