Epson TM-U295 Manual page 93

à Fourth byte (paper sensor information):
Bit Off/On
0
1
2
3
4
5
6
7
Bit 1: ù Becomes 1 (printing not possible) when printing is carried out by FF or paper is
[Default] n = 0
[Reference] DLE DOT, ESC u, ESC v
Appendix D, Transmission Status Identification
EPSON
Hex Decimal
Off 00 0
Off 00 0
On 02 2
Off -- --
On -- --
Off -- --
On -- --
Off 00 0
Off -- --
On -- --
Off -- --
On -- --
Off 00 0
ejected.
ù If ESC c 4 (slip paper-end stop) is not selected, bit 1 does not become 1 (printing
not possible). If ESC c 4 is selected, bit 1 becomes 1 (printing not possible)
when paper-end is detected by the sensor.
ù When the printer goes to the slip wait status, bits 5 and 6 of the third byte
become 1 (paper-end) and bit 1 of the fourth byte becomes 1 (printing not
possible).
TITLE
TM-U295/U295P
Specification
(STANDARD)
Status for ASB
Slip paper selected.
Slip printing possible.
Slip printing not possible.
Not used.
Not used.
Not used.
Not used.
Not used. Fixed to Off.
Undefined.
Undefined.
Undefined.
Undefined.
Not used. Fixed to Off.
SHEET
REVISION
F
NO.
NEXT SHEET
70 69