Epson TM-U295 Manual page 91

ù Since this command is stored in the receive buffer and then executed during normal
command process, there may be a time lag between command reception and status
transmission, depending on the receive buffer status.
ù When the printer disabled is selected using ESC =, this command is disabled, but the
ASB is always enabled.
ù When any of DLE EOT, ESC u, ESC v, or GS I is used, the status transmitted by these
commands and the ASB status must be differentiated by using the table in Appendix D.
À First byte (printer information):
Bit Off/On
0
1
2
3
4
5
6
7
EPSON
Hex Decimal
Off 00 0
Off 00 0
Off 00 0
On 04 4
Off 00 0
On 08 8
On 10 16
Off -- --
Off 00 0
On 40 64
Off 00 0
TITLE
TM-U295/U295P
Specification
(STANDARD)
Status for ASB
Not used. Fixed to Off.
Not used. Fixed to Off.
Drawer kick-out connector pin 3 is LOW.
Drawer kick-out connector pin 3 is HIGH.
On-line.
Off-line.
Not used. Fixed to On.
Undefined.
Paper is not being fed by the paper feed button.
Paper is being fed by the paper feed button.
Not used. Fixed to Off.
SHEET
REVISION
F
NO.
NEXT SHEET
68 67