Epson TM-U295 Manual page 10

REV. SHEET
ESC 3 [Description] n/60 inch ® n x approx. 0.423mm (1/60 inch)
·
E 45
ESC 3 [Description] 1/6 inch ® 4.23mm (1/6 inch)
·
ESC J [Description] n/60 inch ® n 5 approx. 0.423mm (1/60 inch)
49 ·
ESC K [Description] n/60 inch ® n 5 approx. 0.423mm (1/60 inch)
50 ·
[Notes] ESC 2 Set 1/6-inch line spacing. ® Set the initial line
51 ·
spacing.
[Default] n=48 ® n=0
54-2 ·
·
60 [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
·
62 [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
·
64 [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
Bit 0 Not used ® Not available for 2-byte code
65 ·
Bit 1 Not used ® No auto cutter
·
·
69 Bit 1 The contents of the NOTE are corrected and added.
·
67 [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
·
First Bit 5
Not used 00 0 ® Undefined - -
·
70 [Notes] Since the status is transmitted when this command is
buffered in the receive buffer, ® Since this command is stored in the
receive buffer and then executed during normal command process,
TITLE
REVISION SHEET
CHANGED CONTENTS
TM-U295/U295P
Specification
(STANDARD)
Sheet 9 of 10
DATE
(Change)
(Change)
(Change)
(Change)
(Change)
(Change)
(Change)
(Change)
(Change)
(Change)
(Change)
(Addition)
(Change)
(Change)
(Change)