EGO POWER+ TR4200 Operator's Manual page 53

4. Attach garden hose with quick-coupler to the wash port on the
tractor deck as shown in Fig. 24 until you hear a clear click.
The wash port is on the left side of the tractor deck.
5. Turn on the water.
6. With battery packs attached, insert the safety key, and press
the start/stop button for 3 seconds to illuminate the LCD
screen.
7. Depress the parking-brake pedal and simultaneously press the
start/stop button for 3 seconds to illuminate the LCD screen.
8. Pull the PTO switch to start the blade motors and adjust the
blade speed to the highest. Refer to section "To Select Your
Blade Speed Level" in this manual.
9. Flush water under the deck for approximately one minute.
10. Turn off the blade motors by pushing the PTO switch downward.
11. Turn off the water and remove garden hose and quick-coupler from wash port.
12. Remove the quick-coupler from the garden hose and store it in a safe location for future use.
13. Turn off the tractor completely. See section "STOPPING THE ELECTRIC LAWN TRACTOR".
NOTE: When cleaning the deck using the wash port, the tractor can be either in mulching or side discharging mode.
NOTE: If the deck is not clean after one wash cycle, repeat the process until the deck is thoroughly cleaned.
LEVELING THE DECK
WARNING: Always protect your hands by wearing heavy gloves or wrapping the cutting edges with rags or other
materials when performing any maintenance on the blade(s).
◾
If your lawn appears unevenly cut after using the tractor or when the blade(s) is/are reinstalled, the deck may need
adjusting.
◾
Before deciding that leveling of the deck is necessary, make sure that the tires are properly inflated to the
recommended pressure (Please see section "CHECKING THE TIRE PRESSURE" in this manual). Over- or under-
inflated tires can affect the appearance of the cut grass, and proper inflation of the tires may be all that is needed to
resolve uneven cut issues. If the tires are under or over-inflated, the deck cannot be correctly adjusted.
◾
Check for bent blades prior to leveling. Remove and replace any bent blades. See section "REPLACING THE
CUTTING BLADES" in this manual for reference.
◾
Adjust the deck while the tractor is on a level surface. Raise the deck to the highest position.
NOTE: Tractor deck anti-scalp wheels should not contact the ground when leveling the deck.
NOTE: The deck must be adjusted slightly higher in the rear.
Required tools (not supplied): one 13/16" (21 mm) open-end wrench, one 23/32" (18 mm) open-end wrench or
adjustable wrench; one leveling gauge.
24
Wash Port
56-VOLT LITHIUM-ION ELECTRIC LAWN TRACTOR — TR4200/TR4200-FC
Wash-port Quick Coupler
Garden Hose
a
b
c
53