Table of Contents
Advertisement
6
. Control signal connections
6.1
Control signal connection by XLR5 plugs
The digital control signal is transmitted to the projector via a two pole cable screened as per
International standards for the transmission of DMX 512 data. The connection must be serial,
using connectors XLR5 male and female located on the back of MiniLEDko Spot labelled
DMX512 IN e OUT (see diagram). Connectors equipped on MiniLEDko Spot are IP rated, which
ensures protection against water and dust. In order to keep this rating they must be connected
exclusively to other IP rated connectors.
N.B. In case of loss of the signal the MiniLEDko Spot will activate automatically dimmer at full
and CCT at 4.000 K. The maximum number of products that can be connected when using
with DMX is 32 MiniLEDko Spot.
Pin 1 = Ground (GND)
Pin 2 = Data -
Pin 3 = Data +
Pin 4 = Not connected
Pin 5 = Not connected
Note: Once the connection of the line is completed and the last projector's DMX OUT connector is
unused, you need to put on the DMX end of line closure cap received (RME34/G), indispensable
for the last projector of the line.
Controller
Standard
DMX 512
OUT
3
2
1
User Manual 2023
DMX in
DMX out
DMX in
DMX out
coemar.com
18
Advertisement
Table of Contents
