Table of Contents
Advertisement
The use of a thermal/magnetic circuit breaker is recommended. Strict adherence to regulatory norms is
Panorama ACL Daylight should not be powered through a dimmer as this may damage the internal
Prior to connecting the device to mains power, ensure that the mains characteristics are within the rec-
All cabling and connections should be carried out by a suitably qualified personnel.
6
. Control signal connections
6.1
Control signal connection by XLR5 canon
The digital control signal is transmitted to the projector via a two pole cable screened as per International
standards for the transmission of DMX 512 data. The connection must be serial, using connectors XL5 male
and female located on the back of Panorama ACL Daylight labelled DMX512 IN e OUT (see diagram).
Connectors equipped on Panorama ACL Daylight are IP rated, which ensures protection against water and
dust. In order to keep this rating they must be connected exclusively to other IP rated connectors.
DMX OUT
DMX IN
DC IN
DMX IN/OUT
Make sure that screening and conductors are not in contact one another or with the metal housing of the
Pin#1 and housing never must be connected to the power supply unit.
strongly recommended.
switching power supply.
ommended range for the use of Panorama ACL Daylight.
ELECTRONIC BOX
LED
Warning!!
230 VA C
DMX IN
DMX OUT
DC IN
DMX IN/OUT
Warning!
connector.
10
FROM CONTROL SYSTEM
ELECTRONIC BOX
LED
230 VA C
Advertisement
Table of Contents
