Warranty Conditions; Ec Norms - Coemar MiniLEDko Spot User Manual

Hide thumbs Also See for MiniLEDko Spot:
Table of Contents

Advertisement

3. The level of technology of MiniLEDko requires the use of specialised personnel
for all service applications; refer all work to your authorised Coemar service
centre.
4. A good earth connection is essential for the proper functioning of the projector.
Never connect the fixture if there is no earth connection.
5. Mains cables must not come into contact with other cables.
6. Do not operate the projector with wet hands or in an area where water is present.
7. The fixture must never be located in an exposed position, or in areas of extreme
humidity.
Safety:
1. The projector must always be installed with bolts, clamps, or other fixing devices
which are suitably rated to support the weight of the projector.
2. Always use a secondary safety fixing device with chain or steel wire of a suitable
rating to sustain the weight of the unit in case of failure of the principal fixing
point.
3. The external surfaces of the unit, at various points, may reach 60°C. Never han-
dle the unit until at least 10 minutes have elapsed since the LED was turned off.
4. Never install the fixture in an enclosed area lacking sufficient air flow; the ambi-
ent temperature must not exceed 40°C.
5. The projector contains electronic and electrical components which must under
no circumstances be in contact with water, oil or any other liquid. Failure to do
so will compromise the proper functioning of the projector.
2.2

Warranty conditions

1. The fixture is under warranty for 24 months from the purchase date against factory defections.
2. Damage ought to unskillfulness, inappropriate use, or lack of suggested maintenance are
excluded from the warranty.
3. Warranty expires when the projector is opened by unauthorized personnel.
4. Warranty doesn't include the replacement of the fixture.
5. Serial number and model of the fixture are necessary to retrieve informations and assistance
from the dealer.
2.3

EC Norms

1. The fixture satisfies the essential requirements of the directive 2004/108/EC, 2006/95/EC,
2011/65/EC, 2002/96/EC & 2003/108/EC.
2. The fixture is in accordance with the standard EN 50419 (RoHS) and satisfies the requirements
of the directive 2002/96/EC (WEEE).
User Manual 2023
6
coemar.com

Advertisement

Table of Contents
loading

Table of Contents