Table of Contents
Advertisement
Make sure that screening and conductors are not in contact one another or with the metal
housing of the connector. Pin#1 and housing never must be connected to the power supply unit.
7
. Turning the projector on
After having followed the preceding steps described, proceed with the power supply and turn on
the projector connecting it to the mains power.
8.
Setup via RDM
8.1
Quick guide to menu
The MiniLEDko Spot required RDM (Remote Device Management) to set up fixtures. Using an
RDM compliant DMX controller, you can communicate with all the fixtures on a data link without
needing to connect to each fixture individually. RDM lets you set the DMX addresses of all the
fixtures on the link, carry out fixture configuration and retrieve fixture data including details
of any error that has been logged. If two or more identical fixtures are set up with the same
DMX address and in the same DMX mode, they will receive the same instructions and behave
identically. Setting up identical fixtures with the same address is a good tool for troubleshooting
unexpected behavior and an easy way to achieve synchronized action. Setting DMX addresses
via RDM involves running a scan to identify the fixtures that are present on the data link and then
allocating addresses either automatically or manually.
To use RDM:
1. Obtain an RDM-compatible controller such as the RDM UPGRADE INTERFACE B (cod.
AC10011A001 ) application running on a Windows PC.
2. Use a USB cable to connect the PC to a USB/DMX interface box
3. Connect the interface box to the data link.
4. Power the fixture on and carry out an RDM discovery / scan in your RDM-compatible controller.
5. You can then configure or retrieve data from the fixtures on the data link.
N.B. The maximum number of products that can be connected when using with RDM is 32
MiniLEDko Spot.
Warning!
User Manual 2023
19
coemar.com
Advertisement
Table of Contents
