Print Path Page - HID HDP 5000 User Manual

L001675, 1.2

4.6 Print Path page

The Print Path page allows you to view or change the TCP port numbers used to communicate with the
printer.
If these settings are left to the default entry of 0 then the default ports of 9100, 5400 and 5402 are
n
used for the RawSocket TCP Port, the CPS Data TCP Port and the CPS Command TCP Port
respectively.
The CPS Command TCP Port is dependent on the setting of the CPS Data TCP Port and always two
n
units higher.
1. Click Print Path.
2. View the active configuration of the printer in the Current Settings area on this page.
3. Enter new port numbers in the Stored Settings area on this page.
4. Click Submit to save these changes to stored settings in the memory of the printer.
Note: These settings are not lost if the power is removed from the printer.
July 2019
Ethernet web pages - standard procedures
21