HID HDP 5000 User Manual page 12

Telnet Command
store net addr
mask
gateway
dns
domain
opts
from
ifc mode
from
save
load
lpstat
cancel
quit
12
Telnet server
Command Purpose
Store a new IP address.
Store a new address mask.
Store a new default gateway.
Store a new DNS server address.
Store a new DNS domain suffix.
Enable or disable automatic address assignment
using DHCP. Static (non-automatic) addresses will
come from the stored or default settings, depending
on the other settings.
Restore the network settings from either the default
settings or the current settings.
Specify the Ethernet interface mode as:
automatic, full or half duplex; 10 or 100 mHz.
Note: 100 mHz. is not supported by the printer.
Set the Ethernet mode settings from the default or
current settings.
Save all current settings as the stored settings in the
permanent memory.
Take the settings from the stored memory and make
them the current settings.
Display information about the printer status.
This includes the status and device response.
See the printer web page description.
Cancel a specific print job from the print queue.
Stop the current Telnet session.
L001675, 1.2
Command Format
store net addr <ADDRESS>
store net mask <MASK>
store net gateway <ADDRESS>
store net dns <ADDRESS>
store net domain <STRING>
To enable automatic address
assignment:
store net opts dhcp
To disable automatic address
assignment:
store net opts -dhcp
store net from default|current
store ifc mode
auto|10half|10full|100half|100full
store ifc from default|current
save
load
lpstat
cancel 10
quit
July 2019