Table of Contents
Advertisement
MAINTENANCE/SERVICE
Traction
Drive:
Neutral Lock Adjustment
(continued)
4.
Check that with both pump pintle arms locked
into lnter1ock brackets, the ball on neutral start
switch
(C)
is fully
depressed.
If
not,
adjust as
follows:
a) Loosen bolt (E), allowing cable
(F)
to become
slack.
b) Loosen nut (D) and move switch mount (N)
horizontally to adjust position of inter1ock
bracket (G) on pintle arm (H) until dimension
(J) Is 5/16 to 1/2 inch (8 to 13 mm) at both
front and rear pump
locations.
Tighten nut (D).
c) Move bolt (E) until cable
(F)
tightens,
then
move bolt back 1 /8 inch (3 mm). Tighten bolt
(E) to secure the
position.
NOTE:
Cable (F) should be slightly loose
when ground speed lever and steering wheel
are in neutral. If the cable is too loose in
neutral, the pintle arms (H) will interfere with
the inter1ock brackets when the ground speed
lever Is placed in
reverse.
NEUTRAL
START SWITCH
CABLE ASSEMBLY
(8to13mm)
INTERLOCK BRACKET /PINTLE ARM ADJUSTMENT
103
Advertisement
Table of Contents
