Table of Contents
Advertisement
MAINTENANCE/SERVICE
Electrical
System
LAMPS AND BULBS (continued)
REPLAONG MACHINE MONITOR LIGHT BULBS
1.
Tum light switch and
ignition
key to OFF.
2.
Remove six screws (three per side) from
Instrument panel
(A).
While pulling out on top
of instrument panel, pull up until panel clears
side
console.
3.
To replace warning lights (B) for engine oil
pressure, transmission oil pressure or parking
brake:
a) Remove two
wires.
b) Remove retainer clip (C).
c)
Push out entire unit and replace.
NOTE:
It
may be
necessary
to
replace
the
retainer clip (C) when replacing
warning
lights.
4. To replace
gauge
lights, twist and pull bulb
holder (D) from back of gauge and replace
bulb.
NOTE:
Bulb trade #161 (except tachometer).
Tachometer bulb trade #1816
REPLAONG DOME LIGHT BULB
1.
Un-snap plastic lens (D) from fixture by hand.
2.
Replace bulb and reinstall plastic lens.
NOTE:
Bulb t~de #211-2TS.
REPlAONG
TURN SIGNAL INDICATORS
1.
Pull out entire unit
(E),
detach wiring and
replace.
REMOVE INSTRUMENT
PANEL
WARNING LIGHTS
& GAUGE
LIGHTS
DOME
LIGHT AND TURN INDICATORS
83
Advertisement
Table of Contents
