MacDon 9000 Operator's Manual page 53

MAINTENANCE/SERVICE
Gasoline Engine
WBRICATING OIL
Changing engine oil and filter (continued)
6. Install the new filter. Turn the filter onto the
mount until the gasket contacts the filter head.
Tighten the filter an additional 1 / 2 to 3/4 turn
by hand.
IMPORTANT:
Do not use a filter wrench to Install
the oil filter. Over-tightening can damage the
gasket and the filter.
7. Install the oil pan drain plug.
8. Fill the engine with the proper amount of oil.
See "Fuels, Fluids and Lubricants" section for
recommended oil types.
Capacity Gas Engine
With filter change 6 US qts (5. 7L)
Without filter change 5 US qts (4.7L)
(A) - Filler cap - gas engine
9. Operate the engine at low idle and check for
leaks at the filter and drain plug.
10. Shut off engine. Wait five minutes, then check
oil level at dipstick. Add oil if required.
FILLER LOCATION - GAS ENGINE
51