Maintenance Checks; Weekly; Monthly; When Cleaning The Chimney System - Pacific energy ALDERLEA T5 LE Operating And Installation Instructions

Check the following parts for damage such as cracks, excessive corrosion, burned out sections and
excessive warping: (See website for descriptions and more detail)

Weekly:

• Firebrick - Visual, for cracking.
• Door Gasket - sagging, placement, damage.

Monthly

• Brick rail tabs and brick rails.
• Air riser tube in the back of the rebox.
• Back side of airwash chamber.
• Baf e locking pin.
• Boost tube cover.

When Cleaning the Chimney System:

• Top baf e board/blanket.
•

Baf e.

• Top heat shield and mounting bolt.
• Baf e Gasket.
• Brick Rails.
• Manifold.

Blower:

• The blower should be cleaned out a minimum every six months by using a vacuum on the grill openings in
the back and bottom of the blower casing to remove any dust and debris.
Baffle:
• Some warping of the baf e is normal (up to 1/4" or .65cm). Replace if the baf e has permanent warping
greater than this or has cracking or breakage.
• Please contact your Dealer if you experience any of the damage listed above. Continuing to operate your
stove with broken parts may accelerate damage to other parts and may void your warranty
Chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible
should you remove baf e assembly.
DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.
Removal:
Remove retaining pin at the back top of the rebox, just under the baf e. Lift baf e up and pull forward to
disconnect from the supply tube. Tilt baf e sideways to drop down and remove from rebox. Inspect gas-
ket between baf e and supply tube. If necessary, replace with part # 80000365, available from your Paci c
Energy dealer. Re-install baf e assembly in reverse order. The two side pieces of insulation must be tight
against the side rails.
100000353

Maintenance Checks

Baffle Removal
10
ALT 5-LE 140623-28