Connecting The Power Supply; Connecting Accessories; Attaching Protective Caps And Covers - Sartorius Cubis MCA Series Operating Instructions Manual

1
2
6.4

Connecting the Power Supply

Procedure
Check whether the country-specific power plug matches the power
t
supplies at the installation site.
If required: Contact Sartorius Service.
t
Check whether the voltage specifications on the manufacturer's ID label
t
match those of the power supply at the installation site.
If the input voltage is too high or too low: Do not connect the device
t
to the power supply.
Contact Sartorius Service.
t
Connect the device to the power supply at the installation site. To do
t
this, connect the power plug from the power supply cable into the power
socket.
The device is switched on and performs the initial functions for device
y
startup.
6.5

Connecting Accessories

Accessories can be connected to the device. For certain accessory parts,
the covers must be removed in the wall of the weighing compartment, e.g.
for connecting a sample holder module.
Requirements
The accessories must be suitable for the device (see instructions for the
accessories).
Procedure
If a cover for the rear wall of weighing compartment needs to be
t
removed from the device: Remove the top (1) and bottom (2) covers for
the rear wall of the weighing compartment from the device.
Connect the accessories to the appropriate connections on the device
t
(for connections for accessory parts, see instructions for accessories).
6.6

Attaching Protective Caps and Covers

If connections of the device are not being used during operation: We
recommend using the protective caps and covers provided to seal the
connections on the rear wall of the weighing compartment and on the back
of the device.
Procedure
Check whether all unused connections have been sealed.
t
If required: Seal the unused connections on the device using the
t
corresponding covers or protective caps.
Operating Instructions Cubis
Getting Started
| MCA Models 49
®