Remove The Cabinet From The Pallet; Transport The Evse On The Site; Hoist The Cabinet - ABB InCharge Terra 184 Manual

Procedure
1. Do a check on the sensors (A) that
record the shocks during transport.
2. Do a check on the sensors (B)
that record the maximum tilt during
transport.
3. If the sensors (A) show a red
indication or the sensors (B) show a
tilt that is too high, do these steps:
For the transport specifications, refer
to section 10.4.
a. Refuse the delivery of the EVSE.
b. Make a note on the delivery
c. Within three days of the delivery,
d. If you see damage on the cabinet, through the packaging material, do not
e. Contact the manufacturer and give details of the delivery problems. Refer to
4.2.3

Remove the cabinet from the pallet

Preliminary requirements
Procedure
1. Remove the fasteners (A).
2. Discard the fasteners and the pallet.
Refer to section 2.11.
4.3

Transport the EVSE on the site

4.3.1

Hoist the cabinet

Preliminary requirements
9AKK108466A3703-EN | 001
receipt.
ask the transport company for an inspection.
unpack the EVSE.
section 1.12.
• Installation engineer
• The cabinet is unpacked.
Refer to section 4.2.
Inspection and transport
A B
TiltWatch PLUS
ShockWatch
TiltWatch PLUS
ShockWatch
A B
• Open spanner
• Hoisting equipment. Refer
to section 10.5.
A
39