Start A Charge Session; Stop A Charge Session; Remove Condensation From The Cabinet - ABB Terra Mobile 44HV Operation And Installation Manual

Operation
Procedure
1. Park an EV in the parking space. Make sure that the connector of the EV charge
cable can reach the connector on the EV.
2. Energize the EV.
3. Start the charge session. Refer to section 6.5.2.
4. Stop the charge session. Refer to section 6.5.3.
6.5.2

Start a charge session

1. On the touchscreen, select the applicable
2. Remove the EV charge cable from the EVSE.
3. Connect the EV charge cable to the connector on the EV.
4. On the touchscreen, press the
5. If the touchscreen shows a message to authorize the charge session, do the
instruction that the touchscreen shows.
•
•
6.5.3

Stop a charge session

1. On the touchscreen, press the
2. Disconnect the EV charge cable from the EV.
6.6

Remove condensation from the cabinet

Preliminary requirements
Procedure
1. Open the right door. Refer to section 9.1.
2. Set the power module breakers to the off position:
a. Set the power module breakers from the
b. Set the power module breakers from the
3. Energize the EVSE. Refer to section 6.4.
40
Note: If you skip this step, the EVSE selects the correct connector
automatically when you connect the EV charge cable to the EV.
The EVSE charges the EV and shows the progress on the touchscreen.
The status panel shows the status of the EVSE.
Note: When the battery is full, the charge session stops automatically.
Note: In some cases, the EV locks the connector to the EV. To unlock the
connector, obey the instructions for the EV.
• Owner
Note: If the EVSE is off for more than two hours, condensation can occur.
connector button.
Start button.
stop button.
Auto to the Manual position.
Manual to the Off position.
9AKK108467A6997-EN | 003