Installation
Procedure
1. Connect the Ethernet cable (A) to the
Ethernet RJ45 socket (B).
5.7
Tilt sensors installation (option)
5.7.1
General procedure
For all specifications of the tilt sensors, refer to section 10.10.
1. Install the bracket (A). Refer to section
5.7.2.
2. Install the tilt sensors (B). Refer to
section 5.7.3.
3. Connect the tilt sensors. Refer to
section 5.7.4.
5.7.2
Install the bracket of the tilt sensors
Preliminary requirements
52
Note: Daisy chaining of
Ethernet between the
EVSEs or network points is
not supported.
•
Installation engineer
•
Screwdriver 3.5 mm
•
Cross screwdriver size 2
B
•
Tilt sensor lugged
•
Bracket
•
Alternative bracket
9AKK108466A3703-EN | 001
A
A
B