Table of Contents
Advertisement
Preparing the carriage
Checking the
Before positioning the carriage, check the following:
surface of the
workpiece and
-
the carriage to
-
ensure they are
-
clean
-
Placing the
1. Place the carriage on the workpiece.
carriage
2. Place the lateral guide rollers on the workpiece. Correct their position if necessary.
Adjusting the
guide roller
The surface of the workpiece must be clean (no sand, shavings, etc.)
The bottom plate of the carriage must be clean and free of shavings
The drive wheels must not be damaged and must be clean
The guide roller and guide rails must be clean, undamaged and free of
welding spatter
If guide rollers with grooves are used: Ensure that the size of the guide rail is suitable
for the guide rollers.
(c)
(b)
(b)
(a)
The holders (c) for the guide rollers (a)
have five slots in which the guide rollers
can be secured:
1. Loosen the fixing screw (b) at the de-
sired slot.
2. Position the guide roller (a) and extend
it to the desired length.
3. Tighten the fixing screw (b).
(a)
10
Advertisement
Table of Contents
