Table of Contents
Advertisement
16. INSTALLATION OF COREOS,
BOOTOS AND STANDARD MONITOR
OS
For executing the GOT utility, install the BootOS and standard monitor OS on the C drive (built-in flash memory) of the
GOT, or set the OS boot drive to [A: Standard SD card] and insert the SD card with OS files into the GOT.
(BootOS is installed in the GOT at factory shipment. It is not necessary to install BootOS when upgrading of it is
unnecessary.)
This chapter explains the installation using GOT.
GT Designer3
SD card/
USB memory
GT Designer3
Set the OS boot
drive to [A: Standard
SD Card].
GOT
SD card/
USB memory
*1
When execute installation with USB memory, standard monitor OS has to be installed in GOT in advance.
For the writing of OS in GT Designer3, refer to the following.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
POINT
POINT
POINT
CoreOS
In 16.1 to 16.4 of this chapter, only BootOS and standard monitor OS are described.
For CoreOS, refer to the following.
16.5 CoreOS
GOT
BootOS or
standard monitor OS
Write
installation
OS file
*1
SD card/USB memory
Write
SD card
OS file
GOT
BootOS or
OS file
standard monitor OS
upload
installation
*1
SD card/USB memory
16. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS
Install the SD
card in GOT
Install the SD
card in GOT
Install the SD
card/USB
memory in GOT
When GOT is remote, installed
easily using the CF card/
USB memory
The GOT can starts without an
OS installed.
Install OS from GOT to GOT
using CF card/USB memory.
16 - 1
9
10
11
12
13
14
15
16
Advertisement
Table of Contents
