Table of Contents
Advertisement
POINT
POINT
POINT
Any device which utilizes a data communication function is susceptible to the wider effects of local EMC noise.
Therefore, when installing any communication cables care should always be taken with the routing and location of
those cables.
Optional ferrite cores are recommended when the cable route is close to EMC noise sources like welders, large
motors, etc.
All tests have been performed with original Mitsubishi cables. For customer prepared cables, please refer to the
previous page.
GT1450-QLBD
GT1450-QLBDE
GT1450-QMBD
GT1450-QMBDE
GT1455-QTBD
GT1455-QTBDE
Example 1
Programmable
controller
5 - 6
5. UL, cUL STANDARDS AND EMC DIRECTIVE
5.2 EMC Directive
GOT Unit
Ex. GT01-C30R4-8P (as shown in EX.1)
(250mm)
(9.84inch)
140mm
(5.51inch)
Optional
Existing Cables
GT01-C30R4-8P
F
F
F
Comes equipped
Optional
User Made Cables
rd
3
party cables need to be independently
tested by the user to demonstrate EMC
compliance.
F = Ferrite core
Ex. NEC TOKIN - ESD-R-17S or similar
100mm
(3.93inch)
GOT units
Advertisement
Table of Contents
