Installation; Control Panel Inside Dimensions For Mounting Got - Mitsubishi Electric GOT1000 GT14 User Manual

Graphic operation terminal
Table of Contents

Advertisement

6.

INSTALLATION

MOUNTING PRECAUTIONS
• Be sure to shut off all phases of the external power supply used by the system before mounting or removing the
GOT to/from the panel.
Not doing so can cause the unit to fail or malfunction.
MOUNTING PRECAUTIONS
• Use the GOT in the environment that satisfies the general specifications described in this manual.
Not doing so can cause an electric shock, fire, malfunction or product damage or deterioration.
• Never drop cutting chips and electric wire chips into the ventilation window of the GOT when you drill screw holes
or perform wiring.
Otherwise, fire, failure or malfunction may be caused.
• Connect connection cables securely to the specified connectors while the power is turned OFF.
Imperfect connection may cause malfunction or failure.
• Operate and store the GOT in environments without direct sunlight, dust, lamp black, conductive dust, corrosive
gas, combustible gas, high temperature, condensation, wind, rain, vibrations and impacts.
Electric shock, fire, malfunction, product damage or deterioration can be caused.
• Tighten the mounting screws within the specified torque range.
Undertightening can cause the GOT to drop, short circuit or malfunction. Also, undertightening can disable
waterproof or oil proof effect.
Overtightening can cause a drop, short circuit or malfunction due to the damage of the screws or the GOT. Also,
"distortion" of the GOT or the panel may disable waterproof or oil proof effect.

6.1 Control Panel Inside Dimensions for Mounting GOT

Mount the GOT onto the control panel while considering the following control panel inside dimensions.
Vertical installation of the GOT requires a space with the same dimensions as the horizontal installation turned 90
degrees clockwise (seen from the display side).
POINT
POINT
POINT
Applicable cable
Some cables may need to be longer than the specified dimensions when connecting to the GOT. Therefore,
consider the connector dimensions and bending radius of the cable as well for installation.
30 (1.19")
WARNING
CAUTION
152 (5.99")
6.1 Control Panel Inside Dimensions for Mounting GOT
Unit: mm (inch)
6. INSTALLATION
1
2
3
4
5
6
7
8
6 - 1

Advertisement

Table of Contents
loading

Table of Contents