Table of Contents
Advertisement
offset the value from 0 to 255, press the ENTER button to store. Press the MENU button to exit.
Yellow - Yellow home position adjustment
Enter offset mode, select Yellow press the ENTER button to confirm. Use the UP/DOWN button to
offset the value from 0 to 255, press the ENTER button to store. Press the MENU button to exit.
CTO- CTO home position adjustment
Enter offset mode, select CTO, press the ENTER button to confirm. Press the ENTER button to store.
Press the MENU button to exit.
5.3 Error Information
Lamp Startup Fail
It appears when there is no lamp or some wires are damaged.
Temperature Sense Error
It appears when temperature check board is damaged.
Lamp Too Hot Power Off
It appears when temperature is detected higher than 110℃. Check if the unit is properly ventilated, or
fans or temperature check board may is damaged.
Lamp Too Hot Low Power
It appears when temperature is detected higher than 105℃, the unit will run on a low power level.
Maintenance Fixture
It appears when the maintenance remaining time becomes 0S, please enter menu mode and reset the
time.
Lamp On Over 700 Hour
It appears when the lamp has been on over 700 hours, please turn off the lamp.
Memory Initial Fail
It appears when the memory IC is damaged.
CPU-B Error, CPU-C Error, CPU-D Error
19C
A
Advertisement
Table of Contents
