Table of Contents
Advertisement
Figure 5-2: Grounding cable with connector
Step3. Grounding cable plug with USM-100H Equipotential Terminal (See Figure 5-1)
Running BIOS Setup Program
5.3
Your USM-100H SERIES was probably set up and configured by your dealer prior to delivery.
You may still find it necessary to use the BIOS (Basic Input-Output System) setup program to
change system configuration information, such as the cur- rent date and time or your type of
hard drive. The setup program is stored in read- only memory. It can be accessed either when
you turn on or reset the panel PC, by pressing the "Del" key on your keyboard immediately after
powering on the computer.
Install System Software
5.4
Recent releases of operating systems from major vendors include setup programs which load
automatically and guide you through hard disk preparation and operating system installation.
The guidelines below will help you determine the steps necessary to install your operating
system on the panel PC hard drive.
Note!
If required, insert your operating system's installation or setup diskette into the exter-
nal diskette drive until the release button pops out.
The BIOS supports system boots up directly from the Flash disk. You may also insert your
system installation Flash disk into USB port.
Power on or reset the system by pressing the "Del" key to boot into BIOS menu and adjust the
boot device sequence.
You can also press F12 key when booting; a bootable device popup menu will appear, you can
select bootable device that you want. The Point-of-Care Terminal will automatically load the
operating system from the Flash disk.
Some distributors and system integrators may have already pre-
installed system software prior to shipment of your panel PC.
15
POC-421_424 User Manual
Advertisement
Table of Contents
