Table of Contents
Advertisement
7.
Make sure the voltage of the power source is correct before connecting the equipment to the
power outlet. Position the power cord so that people cannot step on it. Do not place anything
over the power cord. If the equipment is not used for a long time, disconnect it from the power
source to avoid damage by transient over voltage.
Caution! Do not leave this equipment in an uncontrolled environment where the storage
temperature is below -40° C (-40° F) or above 70° C (156° F). This may damage the
equipment.
8.
If your computer does not keep the correct time or the BIOS configuration has been reset to
default, the battery may have no charge.
9.
Classification:
1). Class I DC power adaptor
2). No applied part
3). Continuous Operation
4). Not AP or APG category
Warning! This device is not suitable for use in the presence of flammable anesthetic mixture with air,
oxygen, nitrous oxide, or for life support systems.
11.
Environmental protection: follow national requirements to dispose of unit.
12.
Maintenance: to properly maintain and clean the surfaces, use only the approved
products or clean with a dry applicator.
Caution! When servicing the device, always use replacement parts that are qualified to Advantech
standards. Advantech Digital Healthcare cannot war-rant or endorse the safe
performance of third-party replacement parts for use with our medical device.
13.
Make sure the user does not allow contact between SIP/SOPs and the patient at the same time.
14.
When networking with electrical devices, the operator is responsible for ensuring that the
resulting system meets the requirements set forth by the following standards:
–
EN 60601-1 (IEC 60601-1) Medical electrical
equipment
Part 1: General requirements for safety
–
EN 60601-1-1 (IEC 60601-1-1) Medical electrical
equipment
Part 1-1: General requirements for safety
Collateral standard: Safety requirements for Medical electrical systems
–
EN 60601-1-2 (IEC 60601-1-2) Medical electrical
equipment
Part 1-2: General requirements for safety
Collateral standard: Electromagnetic compatibility; Requirements and tests
vi
USM-100 User Manual
Advertisement
Table of Contents
