Table of Contents
Advertisement
2.3
Running the BIOS Setup Program
Your POC-S198 was probably set up and configured by your dealer prior to delivery.
You may still find it necessary to use the BIOS (Basic Input-Output System) setup
program to change system configuration information, such as the current date and
time or your type of hard drive. The setup program is stored in read-only memory. It
can be accessed either when you turn on or reset the panel PC, by pressing the "F2
or Del" key on your keyboard immediately after powering on the computer.
The settings you specify with the setup program are recorded in a special area of
memory called CMOS RAM. This memory is backed up by a battery so that it will not
be erased when you turn off or reset the system. Whenever you turn on the power,
the system reads the settings stored in CMOS RAM and compares them to the
equipment check conducted during the power on self-test (POST). If an error occurs,
an error message will be displayed on screen, and you will be prompted to run the
setup program.
2.4
Installing System Software
Recent releases of operating systems from major vendors include setup programs
which load automatically and guide you through hard disk preparation and operating
system installation. The guidelines below will help you determine the steps necessary
to install your operating system on the panel PC hard drive.
Note!
Some distributors and system integrators may have already pre-
installed system software prior to shipment of your panel PC.
If required, insert your operating system's installation or setup diskette into the exter-
nal diskette drive until the release button pops out.
The BIOS supports system boots up directly from the CD-ROM drive. You may also
insert your system installation CD-ROM disk into your external CD-ROM drive.
Power on or reset the system by pressing the "F2 or Del" key to boot into BIOS menu
and adjust the boot device sequence.
You can also press F12 key when booting; a bootable device popup menu will
appear, you can select bootable device that you want. The Point-of-Care Terminal will
automatically load the operating system from the diskette or CD-ROM.
If you are presented with the opening screen of a setup or installation program, follow
the instructions on screen. The setup program will guide you through preparation of
2.
Prepare the grounding cable and the other terminal link to
hospital ground/earth system.
Figure 2.9 Grounding cable
3.
Grounding cable plug with Equipotential Terminal
with connector
13
POC-S198 User Manual
Advertisement
Table of Contents
