To Set Up The U4164A Module - Keysight Technologies U4164A Service Manual

2 Preparing for Troubleshooting or Performance Testing

To set up the U4164A module

To set up the U4164A module for troubleshooting/servicing, you first need to install it in one of the
slots of the AXIe chassis. Then connect the chassis to the host PC via a PCIe/USB link. On the host
PC, install the Logic and Protocol Analyzer (6.20 or higher) application to configure and control the
U4164A module. Connect the U4164A module to a probe and appropriate pod connector cables.
You can find the detailed instructions for configuring and installing the U4164A module into the AXIe
chassis in the
16
AXIe based Logic Analysis & Protocol Test Modules Installation Guide.
Keysight U4164A Logic Analyzer Service Guide