Starting Procedures, Trucks With Keyless Start Option - Yale VERACITOR GCC030VX Operating Manual

Operating Procedures
9. Make sure lift truck hood is closed.
10. Turn the key to the ON position. If lift truck is equipped
with a diesel engine and engine is cold, the cold start indi-
cator light will illuminate and the cold start circuit will be
energized.
11. If the truck is equipped with Operator Password feature,
enter correct operator, supervisor, or service password.
12. On trucks equipped with a LPG or gasoline engine, turn
the key to the START position to engage the starter. The
word "Cranking" and a 30-second countdown timer will
appear on the LCD screen when the key is in the START
position.
On lift trucks equipped with a diesel engine, if cold start
delay is required, the cold start indicator will be illuminated
and a countdown time of ten seconds is displayed. When
countdown reaches 0, turn the key to the START position
to engage the starter.
For all engine types, if engine fails to start after 30 sec-
onds, the starter will shutdown for 60 seconds to cool off. A
60-second countdown timer will appear on the LCD screen
showing the time remaining before a restart attempt can be
tried. To restart engine, repeat Step 10 through Step 12.
72
Starting Procedures, Trucks With Keyless
Start Option
WARNING
LPG is very flammable. An odor of LPG fuel can indi-
cate a leak in the fuel system. DO NOT start the engine
until the fuel leak is repaired and the atmosphere is
free of LPG.
WARNING
Gasoline is extremely flammable. Do not start the
engine if a gas leak is detected.
NOTE: Lift trucks equipped with Mazda 2007 emission
compliant engines have a "Clear Flood Mode" programmed
into the ECU. When the accelerator is depressed more
than 80% during cranking, the ECU will not allow any fuel
into the gasoline or LPG engines. This allows the engine to
clear any excess fuel out of the intake manifold and cylin-
ders.
1. If the lift truck uses LPG fuel, open the fuel valve on the
LPG tank.
NOTE: If the ambient temperature is below freezing [0 °C
(32 °F)], perform Step 2 through Step 6 below for lift trucks