Install Wheel In Tire - Yale VERACITOR GCC030VX Operating Manual

Maintenance
4. Remove the wheel rim from the
tire.

Install Wheel in Tire

WARNING
Damage to the tire and wheel assembly and injury or
death can occur if you do not do the following proce-
dures:
• Clean and inspect all parts of the wheel before
installing the tire.
• DO NOT use any damaged or repaired wheel parts.
• Make sure that all parts of the wheel are the correct
parts for that wheel assembly.
• DO NOT mix parts between different types or manu-
facturers of wheels.
180
• DO NOT mix types of tires, type of tire tread, or
wheel assemblies of different manufacturers on any
one lift truck.
Do not use a steel hammer on the wheel. Use a rubber,
lead, plastic, or brass hammer to put parts together.
Make sure that the side ring is in the correct position.
The ends of the side ring must not touch. The clear-
ance at the ends of the side ring will be approximately
13 to 25 mm (0.5 to 1.0 in.) after it is installed. If the
clearance is wrong, the wrong part has been used.
1. Clean and inspect all parts of the wheel. Paint any parts
that have rust or corrosion.
2. Install a new inner tube in the tire. Used tubes and flaps
can cause tire failure.
WARNING
Do not lubricate the tire bead with antifreeze or petro-
leum-based liquid. Vapors from these liquids can
cause an explosion during inflation or use.
3. Apply a rubber lubricant or a soap solution to the tire
bead and tube.
4. Install a new tire flap.