Remove The Parking Brake And Traction Motor; Install Parking Brake And Traction Motor - Yale ERP15-20VT Service Manual

Transaxle Assembly
REMOVE THE PARKING BRAKE AND
TRACTION MOTOR
WARNING
Cleaning solvents can be flammable and toxic and
can cause skin irritation.
solvents, always follow the solvent manufacturer's
recommended safety procedures.
WARNING
The traction motor is heavy. Be sure that all lifting
devices are suitable and of adequate capacity to lift
the traction motor.
1. Position transaxle on blocks with studs down. Se-
curely support in this position.
2. Remove parking brake assembly from traction mo-
tor:
a. Remove four capscrews, lockwashers, and
washers holding brake assembly on traction
motor. See Figure 3.
b. Pry evenly on opposite sides to remove brake
assembly from brake hub. Remove brake as-
sembly by hand.
c. Remove snap ring holding brake hub on trac-
tion motor shaft. Slide hub from shaft. Remove
snap ring and woodruff key from beneath hub.
3. Remove traction motor from transaxle:
a. Install an eyebolt to traction motor shaft and
attach an overhead lifting device of adequate
capacity to eyebolt.
b. Remove four capscrews and washers mounting
traction motor to transaxle.
c. Lift traction motor from transaxle using over-
head lifting device.
INSTALL PARKING BRAKE AND
TRACTION MOTOR
WARNING
Cleaning solvents can be flammable and toxic and
can cause skin irritation.
solvents, always follow the solvent manufacturer's
recommended safety procedures.
4
When using cleaning
When using cleaning
WARNING
The traction motor is heavy. Be sure that all lifting
devices are suitable and of adequate capacity to lift
the traction motor.
1. Position transaxle on blocks with studs down. Se-
curely support in this position.
2. Install traction motor on transaxle:
a. Install an eyebolt to traction motor shaft and
attach an overhead lifting device of adequate
capacity to eyebolt.
b. Lightly lubricate inside lip of transaxle input
shaft with multipurpose grease to ensure seal
seats properly on traction motor shaft. It is not
necessary to lubricate traction motor shaft as
it is lubricated internally within the transaxle.
See Figure 4.
1. CAPSCREW
2. LOCKWASHER
3. WASHER
4. PARKING BRAKE
ASSEMBLY
5. TRACTION MOTOR
Figure 3. Traction Motor and Parking Brake
1300 YRM 1330
6. CAPSCREW
7. WASHER
8. MOTOR SHAFT
9. TRANSAXLE
10. INPUT SEAL