Display Subassembly Removal And Replacement; Keypad Removal And Replacement; Prox Reader Removal And Replacement - Toptech MultiLoad II Mobile Installation Manual

Chapter 7 – Troubleshooting
7.1.3 D S
ISPLAY UBASSEMBLY
Removal:
1. Disconnect the flat display cable (after releasing the cam lock), display power cable and the keypad
cable.
2. While supporting the display subassembly, remove the four mounting screws.
3. Do not attempt to disassemble the display subassembly. Return entire subassembly to Toptech for repair
after receiving an RMA number.
Installation:
1. While supporting the display subassembly, install the four mounting screws.
2. Connect the keypad cable, display power cable and the flat display cable.
3. Verify routing and clearance of the cable
7.1.4 K R
EYPAD EMOVAL AND
Removal:
1. Disconnect the keypad cable from the back of the keypad.
2. Using a #2 screwdriver, remove all screws holding on the keypad plate.
3. Remove the plate.
4. Using a flat screwdriver, carefully pry out the keypad.
Installation:
1. Carefully install the keypad into the cover.
2. Install the keypad plate and retaining screws.
3. Reconnect the keypad cable to the keypad.
7.1.5 P R
ROX EADER
Removal:
1. Disconnect the prox reader cable from the display subassembly.
2. Remove the two nuts holding prox reader.
3. Remove the prox reader.
Installation:
1. Reinstall the prox reader with the two nuts.
2. Connect the prox reader cable to the display subassembly.
MultiLoad II Mobile Installation Guide: Version C
R R
EMOVAL AND
R :
EPLACEMENT
R R
EMOVAL AND EPLACEMENT
:
EPLACEMENT
:
40