Table of Contents
Advertisement
Chapter 6 – MutliLoad Configuration
CHAPTER 6
6.1
O
VERVIEW
The MultiLoad must be configured to use the modem and to connect to TDS. Configuration is performed by
putting the MultiLoad in Program Mode.
To access Program Mode, the MultiLoad II terminal operator must:
1. Move the Program Mode switch into the active position.
2. At the idle card in screen, enter the security code (default security code is 000000) and press the <Next>
key.
6.2
N
AVIGATING THE
The following describes how to navigate the system, select field values, perform data entry, and toggle options on
and off.
Note: All unknown or not allowed sequences of switch or key actuations are rejected and have no
impact on the software or measurement data.
6.2.1 M
ENUS AND
The MultiLoad II Main Menu is shown below. From this menu, you select one of four main functions.
The reverse video highlight bar indicates the current selection. Press Next to select Diagnostics, and then press
the Enter key to go to the Diagnostics Menu.
MultiLoad II Mobile Installation Guide: Version C
M
L
C
ULTI
OAD
S
:
YSTEM
S
CREENS
Views and Inquiries
Next
ONFIGURATION
M A I N
M E N U
Configuration
Diagnostics
SD Card
Prev
Exit
Enter
28
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiLoad II Mobile and is the answer not in the manual?
Questions and answers