Suggested Setup For Tds; Network Configuration - Toptech MultiLoad II Mobile Installation Manual

Chapter 6 – MutliLoad Configuration
Parameter
RCU Address
Card Reader Type
(Excluding SMP)
Processing Mode
Swing Arm Secondary
(Excluding SMP)
Password
Modem Dial
Host Login
Terminal SPLC
Terminal Name
Truck Number
Carrier ID
TDS Retry Interval
Seller ID
Consignee
6.5 S
UGGESTED
Place the MultiLoad in Program Mode by entering the security code (default is 000000) at the idle card in screen,
and press the <Next> key.
6.5.1 N C
ETWORK
1. Navigate to the Configuration menu item and press the Enter button.
2. Navigate to the Network menu item and press the Enter button.
3. Enter the following network parameters (assuming the modem is using its default settings):
a. Network: ENABLED
b. IP Address: 192.168.13.13
MultiLoad II Mobile Installation Guide: Version C
Description
Address of the MultiLoad II RCU unit. The values are 001–099.
Enable or Disable the card reader.
Enable or Disable remote computer control. Set the default fueling operation type.
When swing arms are used, one bay RCU will be designated as the secondary RCU.
Enable this parameter to identify the RCU as secondary. When this parameter is
disabled, the RCU will be considered primary for swing arm purposes. If no swing
arms are involved in the bay, disable this parameter.
Program Mode password.
password can consist of seven alphanumeric characters. The terminal manager
should assign a password to each person/group. For example, employee #1 will be
password #1. When employee #1 accesses the Weights & Measurements Menu, his
code will be part of the change log event.
Measurements Menu Access" Any changes made in the log will be prefaced with the
ID#.
(This feature has not yet been implemented.)
Enter the username and password. Both the username and password should be 8
characters long, and should be concatenated together and entered as one string in
this field.
Enter the name of the terminal or depot in this field. This name will be printed on Alibi
logs and Meter Tickets, if they are enabled.
Enter the identifier of the truck with which this MultiLoad is associated.
The number of minutes between attempts to contact TDS. The default is 15.
S TDS
ETUP FOR
ONFIGURATION
There may be up to five passwords entered.
It will say "ID: 1 has Weights &
34
Each