Test Network Delay And Packet Loss; Export Network Packet - HIKVISION LTN07128/256 User Manual

13.3.2 Test Network Delay and Packet Loss

Network delay is caused by slow response of the device when oversized data information is not
limited during transmission under certain network protocol, e.g. TCP/IP. Packet loss test is for
testing network packet loss rate that is the ratio of lost data packet and total number of
transmitted data packet.
Steps
1. Go to Maintenance → Network → Network Detection.
2. Select a network card in Select NIC.
3. Enter the destination IP address in Destination Address.
4. Click Test.

13.3.3 Export Network Packet

After the recorder accessing network, you can use USB flash drive to export network packet.
Before You Start
Prepare a USB flash drive to export network packet.
Steps
1. Insert the USB flash drive.
2. Go to Maintenance → Network → Network Detection.
3. Select network card in Select NIC.
4. Select the USB flash drive in Device Name. You can click Refresh if the connected local backup
device cannot be displayed.
5. Optional: Click Status to view the network status.
6. Click Export.
Note
It will export 1 MB data each time as default.
Network Video Recorder User Manual
Figure 13-2 Test Network Delay and Packet Loss
Figure 13-3 Export Network Packet
118