Configure Port Mapping (Nat) - HIKVISION DS-7764NI-M4 User Manual

13.5 Configure Port Mapping (NAT)

Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
Before You Start
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of
the router to which your device is connected. When the network working mode of the device is set
as multi-address, the Default Route of the device should be in the same network segment as that
of the LAN IP address of the router.
Universal Plug and Play (UPnP™) can permit the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP™ function to enable the fast connection of the device
to the WAN via a router without port mapping.
Steps
1. Go to System → Network → TCP/IP → NAT .
2. Check Enable.
3. Select Mapping Type as Manual or Auto.
- Auto: If you select Auto, the port mapping items are read-only, and the external ports are set
by the router automatically.
- Manual: If you select Manual, you can edit the external port on your demand by clicking to
activate External Port Settings.
Note
You can use the default port No., or change it according to actual requirements.
●
External Port indicates the port No. for port mapping in the router.
●
The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value of
●
the other ports should be between 1 and 65535 and the value must be different from each
Network Video Recorder User Manual
Figure 13-3 Port Mapping Setting
115