Configure Port Mapping (Nat) - HIKVISION DS-9600NI-I8 Series User Manual

Receiver
The receiver's name.
Receiver's Address
The e-mail address of the user to be notified.
Enable Attached Picture
Check to send e-mail with attached alarm images. The interval is the time between sending
two subsequent alarm images.
3. Click Apply.
4. Optional: Click Test to send a test email.

12.5 Configure Port Mapping (NAT)

Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
Before You Start
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of
the router to which your device is connected. When the network working mode of the device is set
as multi-address, the Default Route of the device should be in the same network segment as that
of the LAN IP address of the router.
Universal Plug and Play (UPnP™) can permit the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP™ function to enable the fast connection of the device
to the WAN via a router without port mapping.
Steps
1. Go to System → Network → TCP/IP → NAT .
2. Check Enable.
3. Select Mapping Type as Manual or Auto.
Network Video Recorder User Manual
Figure 12-4 Port Mapping Setting
106