Endless Pools Fastlane Installation Manual And User's Manual page 21

Fig 51
Filter Change
Skimmer Basket &
Cage Assembly
Cartridge Filter
Skimmer Filter Body
1. Turn the circulating pump off.
• For pools without the optional Electric Heater-
Controller: Turn the power off to the system at the circuit
breaker or shut-off.
• For pools with the optional Electric Heater-Controller:
Press and hold the P1 button on the keypad (attached to the
Equipment Hutch) until the keypad display reads, "OFF." It
will take an additional few seconds for the pump to actually
turn off. The pump will turn back on automatically after 30
minutes.
2. Once the circulating pump is off, pull out the internal
skimmer basket and cage assembly.
• Note: if there is debris inside the skimmer basket, then the
cage can be disconnected from the cylinder by turning the
cage a 1/4 turn counter-clockwise.
3. Reach inside the skimmer-filter body and unthread the filter
and remove.
4. Clean the filter with a filter specific detergent or replace the
filter as necessary.
5. Place the filter back into the body and thread into place.
6. Place the skimmer basket and cage assembly back into
the body.
7. Turn the pump back on.
• For pools without the optional Electric Heater-Controller:
Turn the power back on to the system at the circuit breaker
or shut-off.
• For pools with the optional Electric Heater-Controller: Press
the P1 button on the keypad (attached to the Equipment
Hutch) once. This will turn the circulating pump back on.
Water Quality System
Filter
• If the pool has been contaminated with any debris during
installation, it may be desirable to clean or exchange the car-
tridge filter at this time.
• Typically, the cartridge should be cleaned or replaced every 4
months or when a significant reduction of flow into the pool is
noticed. If you have purchased the optional heater/controller,
"FLO" will appear on your keypad when it is time toclean or
change your filter..
Placarding the Fastlane Pool
Place the included eight no diving into pool/keep children
supervised at all times stickers on all four sides of the pool, on
the inside and outside top rail area of the liner, before using the
Fastlane Pool.
NO DIVING into the Fastlane Pool.
Please keep children supervised at ALL times!
Endless Pools is an industry leader in customer service.
Please call the Endless Pools Customer Service Department at
1-800-910-2714 with any questions or inquiries regarding the
Fastlane Pool.
Additional water quality and swimming products are always
available at www.myendlesspools.com
Winterizing the Fastlane Pool
If the Fastlane Pool is to be taken apart:
1. Turn off the power at the circuit breaker
2. Disconnect and remove the Fastlane Unit from the pool
3. Disassemble the Fastlane Pool
4. Drain/blow out the water lines and the filtration equipment
5. Store the pool and equipment
If the Fastlane Pool is to be left together (i.e. the pool has a
security cover):
1.Remove the skimmer (if the pool is equipped with a skim fil-
ter, remove the skimmer and housing, but leave the L-brack-
ets attached to the rails)
20