Mitsubishi Electric FR-CS82S-025 Instruction Manual page 81

 Selecting a parameter by function group number to change its setting
The following shows the procedure to change the setting of
Operating procedure
1.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
2.
Selecting the parameter setting mode
Press
3.
Enabling the function group selection
Press
"
Protective function parameter.
4.
Selecting a parameter
Press
value. "
5.
Changing the setting value
Press
and "
80
5. PARAMETERS
5.1 Parameter list
to choose the parameter setting mode.
or until "
" will appear, which shows that the operation panel is ready for selection of a number in the group of
or until "
(initial value)" appears.
or to change the set value to "
" are displayed alternately after the setting is completed.
P.H400 (Pr.1) Maximum frequency
" (Protective function parameter) appears. Press
" (
P.H400 Maximum frequency
". Press
.
to confirm the selection.
) appears. Press to display the present set
to confirm the selection. " "