Mitsubishi Electric FR-CS82S-025 Instruction Manual page 151

NOTE
• An instantaneous power failure occurring during tuning will result in a tuning error. After power is restored, the inverter starts
normal operation. Therefore, when the STF (STR) signal is ON, the motor starts forward (reverse) rotation.
• Any fault occurring during tuning is handled as in the normal operation. However, if the retry function is set, no retry is
performed.
• The set frequency monitor displayed during the offline auto tuning is 0 Hz.
 Changing the motor constant
• The motor constants can be set directly when the motor constants are known in advance, or by using the data measured
during offline auto tuning.
NOTE
• If "9999" is set, tuning data will be invalid.
Parameters referred to
Pr.9 Electronic thermal O/L relay
Pr.71 Applied motor page 147
Pr.156 Stall prevention operation selection
Pr.178 to Pr.182 (Input terminal function selection
Pr.195 (Output terminal function selection)
150
5. PARAMETERS
5.9 (C) Motor constant parameters
page 112
page 119
page 142
page 126