DT9002
The importance of the
code
Levels of authorisation
Typing the code in
20180621-V1
7. Setting-up
7.1. Typing the code (password) in
You may enter the menu only after you have typed your
code in. The code is made from 3 numeric characters. This
solution prevents unauthorised persons from changing the
settings of the instrument.
•
User level: allows the modification of the most necessary
parameters only. The rest of the menu is not even shown
for users. The user code default factory setting is: 000.
•
Supervisor level: allows the modification of all
parameters for the authorised person. The supervisor code
default factory setting is: 100.
1. Press the MENU button. The blinking
shows that the device is asking for the code.
2. Three zeros appear:
blinking.
•
Pressing the ▲ button you can increase the value of the
blinking number:
,
,
,
,
•
Pressing the ► button to select the next digit.
3. Pressing the ▲ and the ► buttons, type in either the user
code or the supervisor code.
4. Press the MENU button. If a correct code has been type
in, the mnemonic
mnemonic
stays there for 2.5 seconds; then the first menu item is
shown on the display:
5. If an incorrect code has been typing in, the mnemonic
(BAD Code) is shown on the display and stays
there for 2.5 seconds; then the instrument exits from the
menu, and goes on with the measurement.
Start typing the code in again from Point 1.
. The zero at the left side is
,
,
,
,
,
(login as a user) or the
(login as a supervisor) is displayed and
.
mnemonic
, etc.
25