Wacker Neuson RD 24 Instruction Manual page 92

Operation
Towing
Towing
After towing
Separating the hydrostatic
drive power train
Activating the hydrostatic
drive power train
92
1. Drive lever [501] — CENTRE
2. Shut down diesel engine, if still functional.
3. Secure machine against rolling away with wedges or blocks.
4. Interrupt frictional connection of the hydrostatic drive (see text below).
5. Disable parking brakes (see text below).
6. Tow only with towing bar (brakes not functional).
The machine may only be towed with low speed 1 km/h (0.6 mph). The
maximum towing distance is 500 m.
1. Shut down the diesel engine.
2. Secure machine against rolling away with wedges or blocks.
3. Reestablish frictional connection of the hydrostatic drive (see text
below)
4. Actuate parking brakes (see text below).
5. Remove towing bar.
C
A
B
Only if the oil flow can circulate without pressure in the hydraulic system,
can the machine be towed.
For this, perform the following at both high pressure valves:
1. Loosen lock nut [A] at the drive pump [C].
2. Screw in the locking screw [B] until the screw end flushes with the
lock nut.
1. Screw out the locking screw [B] until the stop.
2. Tighten lock nut [A].
15064
BA RD24_RD28 en us 06