Table of Contents
Advertisement
Foreword
Loading and transporting
Load securing
1
2
3
4
H
S
H x 100
L =
S
28
Special notes
1
Variant
and variant
must not necessarily be arranged crosswise.
Do not use any lashing device unless it is of sufficient dimension,
bears the corresponding marking, and has been subjected to a valid
inspection.
Lash the machine with appropriate lashing devices onto the loading
area, using only the marked lashing lugs.
Observe the load for the lashing point(s) at the vehicle / load platform
and at the load / roller. Do not overload the lashing points with a
tensioning device (see the loading chart).
To increase load safety, use additional precautions for securing
the load including, e.g., wheel stop wedges, or a positive fit at the
gooseneck.
Store the machine on the load platform, placing two
continuous and clean strips of anti-slide mats (grammage
approx. 10 kg/m², loadable up to 630 t/m², 10 mm thick,
friction factor µ ≥ 0.6) under every roller drum / tyre.
16067
Maximum permissible ramp slope: see loading chart
[L]
Ramp length (mm)
[H]
Difference in height (mm)
[S]
Ramp slope (%)
16068
Make certain to use a proper load distribution plan.
] Center of gravity
[
17367
2
may be combined. The lashing devices
N O T E
BA RD24_RD28 en us 06
Advertisement
Table of Contents
