Converter Alarm (Function N-3) - Toshiba LF620 B Series Instruction Manual

●Changing the self-diagnosis function setting
The following is an example to change the self-diagnosis setting from OFF to ON.
Switch operation
STEP1
STEP2
STEP3
STEP4(=END)

8.2.26 Converter Alarm (Function N-3)

If "Converter alarm output" is set for Digital output function, a digital signal will be output in case the
converter's self-diagnosis function detects an error.
In this case, you can set whether the empty pipe alarm is to be included in the converter alarm items.
Selection items
CONV ONLY
WITH EMP
* For other alarm items, see 8.2.25 "Self Diagnosis ON/OFF Setting."
Display example
N:SELF CHK
Select "SELF CHK" from the setting item
1 EMPTY
selection menu.
2 SELF CHK
3 CONV ALM
4 EXIT
ESC
SELF CHK
The current setting (OFF in this example)
appears.
OFF
Then push
* Pushing
ESC
screen.
SELF CHK
The switches at the bottom change.
(
OFF
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push
SELF CHK
You can continue to change the setting item.
Push
ON
items.
When the desired item is selected, push
SELF CHK
When you push
to confirm whether the setting is OK or not.
ON
If OK, push
setting, push
SET OK?
Pushing
and exits the setting screen.
ESC N O
O K
Empty pipe alarm is not included in the converter alarm
output items.
Empty pipe alarm is included in the converter alarm
output items.
－ 96 －
6 F 8 A 0 9 9 7
Description
.
returns you to the menu
ESC
are shown.)
.
to change the selection
: Selected item is scrolled up.
: Selected item is scrolled down.
to set the item temporarily.
, a message appears
O K
. If you want to redo the
N O .
ESC
cancels the setting operation
Description