Toshiba LF620 B Series Instruction Manual page 64

For example, if the setting range is 10m/s and display digit setting is 1/100, the measured value will
be displayed to the first decimal place.
Setting range＝1 . 5 0 0 0 0 m
Maximum effective digits
Likewise, when the setting range 1m/s and display digit setting is 1/100, the measured value will be
displayed to the second decimal place.
The numbers less than the displayed digits will be rounded.
Note: The maximum display digits for flow velocity, flow rate and custom value are 7 digits.
If the measured value exceeds 7 digits, the displayed value remains fixed at the maximum display
value.
● Changing the totalized flow volume direction
You can change the totalized flow volume direction as described below.
The following is an example to change the Display 1 setting from Fixed forward totalized flow (F)
to Bidirectional flow (B).
Switch operation
STEP1
STEP2
STEP3(=END)
maximum effective digits
Display example
DSPL1
Select "DSPL1" from the setting item
selection menu.
3
m F
The currently set display setting (m
this example) appears.
Then push
ESC
DSPL1
The switches at the bottom change.
(
3
m F
At the same time, the cursor appears.
DSPL1
Push
third unit (totalized flow direction) and then
3
m B
push
Then push
temporarily.
DSPL1
Pushing
whether the setting is OK or not.
3
m B
If OK, push
setting, push
Pushing
SET OK?
and exits the setting screen.
O K
ESC N O
－ 63 －
3
／min
One hundredth of
Description
.
are shown.)
to move the cursor to the
to change the direction.
to set the display unit
shows a message to confirm
O K
. If you need to redo the
N O
.
ESC cancel the setting operation
6 F 8 A 0 9 9 7
3
F in