Assignment Of Terminal Block Output - Omron ZS-HL Series User Manual

Section6
Settings for Terminal Block Output
 Circuit Specification
The following circuit configuration is employed for the total of 17 outputs including data
output (D0 to D15) and GATE signal.

Assignment of Terminal Block Output

Sets the output contents for the real-time parallel output unit. Depending on the selected
mode, the setting value differs.
 FUN mode-[I/O SET]-[TERMINAL]-[OUT]
• For Single-Task mode
Setting
NONE
MEASURE
JUDGE
• For Multi-Task mode
Setting
NONE
MEASURE
JUDGE
ZS-HL
6-10
User's Manual
• ENPN output type (ZG-RPD11)
ZG-RPD11
15 5.1
0 V (shared internally
with ZS-HLDC)
ZS-HLDC GND lead (cable color: blue)
Does not output to the real-time parallel output unit.
Compared to the case when the measured value or judgment is output, the
sampling cycle becomes short.
(Default Value)
Outputs the measured value to the real-time parallel output unit.
Outputs the judgment result to the real-time parallel output unit.
Does not output to the real-time parallel output unit.
Compared to the case when the measured value or judgment is output, the
sampling cycle becomes short.
(Default value)
TASK1 The measured value of the task selected here is output to the real-time paral-
lel output unit.
TASK2
TASK3
TASK4
REPEAT Continuously outputs TASK1 to TASK4.
Outputs the judgment result to the real-time parallel output unit.
• EPNP output type (ZG-RPD41)
Load
ZS-HLDC
20 mA(max.)
DC24 V
ZS-HLDC GND (0 V) lead
(cable color: blue)
Description
Description
ZG-RPD41
DC24 V
15
5.1
24 VDC (shared internally
with ZS-HLDC)
Load
20 mA (max.)