Notices For Customers In The Usa; Fda Classification Information - Darkly Labs EMBLASER 2 User Manual

Hide thumbs Also See for EMBLASER 2:
Table of Contents

Advertisement

Notices for Customers in the U.S.A.
Power Cable
At voltages over AC 125 V (U.S.A. only): The power cable must be rated for the voltage in use, be
at least AWG no. 18 gauge, and have SVG insulation or better with a NEMA 6P-15 plug rated for
AC 250 V 15 A.
Federal Communications Commission (FCC) Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/television technician for help.
CAUTIONS
Modifications
The FCC requires the user be notified that any changes or modifications made to this device
that are not expressly approved by Darkly Labs may void the user's authority to operate the
equipment.
Interface Cables
Use the interface cables sold or provided by Darkly Labs for your equipment. Using other
interface cables may exceed the limits of Class B Part 15 of the FCC rules.
Notice for Customers in the State of California
WARNING: Handling the cord on this product may expose you to lead, a chemical known to
the State of California to cause birth defects or other reproductive harm. Wash hands after
handling.

FDA Classification Information

Machine Laser Class:
Laser Diode:
Wavelength:
Max. Average radiant power
Class I
Class IV
445-455nM
5 watts
8

Advertisement

Table of Contents
loading

Related Products for Darkly Labs EMBLASER 2

Table of Contents