Table of Contents
Advertisement
Connecting via USB
17
1.
Start Laserweb
Double click on the Laserweb icon to run the software.
When running, click the 'Comms' tab on the left panel.
2.
Set Machine Connection
Set the following values in the Machine Connection tab.
Machine Connection:
USB / Serial Port:
Baud-rate:
3.
Click on 'Connect'
Clicking on 'Connect' will start Laserweb communicating
directly with your Emblaser 2.
4.
Check for Connection
When the connection is established, the console window
will report the following:
Machine Connected
Firmware smoothie edge-XXXXXXXX detected
USB
Select your appropriate port
115200
Advertisement
Table of Contents
