Unblocking The Air-Assist Nozzle - Darkly Labs EMBLASER 2 User Manual

Unblocking the Air-Assist Nozzle

1.
Jog the laser unit up
Before you begin cleaning the lens, ensure the laser unit is
at its highest position. Use Laserweb to jog the laser unit to
this position.
NEVER force the laser unit to move by hand.
Always use Laserweb to adjust its height.
2.
Start air-assist running
Connect to your Emblaser 2 via Laserweb and type the
following command into the 'Console Window' and pressing
'Enter':
M08
This will start your air-assist running.
3.
Unblock the nozzle
Insert a pin or needle into the nozzle to unblock the opening.
4.
Stop the air-assist
Once you feel air blowing through the nozzle, stop the air-
assist by typing the following command into the 'Console
Window' and pressing 'Enter':
M09
This will stop your air-assist running.
25